Laptop HP G62-b31EE won’t turn on, won’t power on, there is no display, just a black screen. This is a general diagnostic and repair steps to fix those problems.
Troubleshooting laptop HP G62-b31EE won’t boot, won’t power on, no display just black screen
When you push on the Power Button the Power led lights ON or NOT, your HP G62-b31EE won’t start up, and there is no display just a black screen. Possible problem and the fixes steps:
Battery has no charge left + AC adapter failed; you press the power button on laptop HP G62-b31EE nothing happens, laptop won’t turns on and there is no display, the battery has no charge left, the motherboard doesn’t receive any power, laptop cannot turn on. You plug in the AC adapter but that doesn’t help, your laptop HP G62-b31EE still won’t power on, there is a chance you have failed AC adapter. In this case try with another charger or check AC adapter with a Multimeter. If it’s dead, replaced with a new one, (How to check AC adapter with Multimeter).
Power circuit in wrong state or Over volt protection trips; you press the power button but nothing happens, laptop HP G62-b31EE won’t turns on and there is no display just a black screen, your laptop has static electric charge made power circuit in wrong state. Unplug AC adapter, take out the battery and hold down power button for 30 seconds, the static charge will dissipate. Plug in the AC Adapter and turn on your laptop HP G62-b31EE. This should restore the system to normal operating mode.
Screen faulty or bad video cable connection; laptop HP G62-b31EE turns on, but screen is black, with Power led lights ON. Test the laptop with an external monitor connected to the HDMI port, VGA port or any Display port, press the appropriate key to switch to it. If the external monitor works fine and load the operation system, most likely you have a faulty screen or bad video cable connection. Check them and replace the faulty one.
Power button failed; the charge led lights on when you plug in the AC adapter, but laptop won’t turn on when you press the power button. Probably you have a Power button failure. The HP G62-b31EE Power button has to be repaired or replaced; you can short the power button borne with conductor wire to see if laptop turns on, (How to Test Power Button).
Hardware failure; the laptop powers on, but there is no display just black screen with Power led lights ON or your laptop HP G62-b31EE stock on logo or restart. In this case, it’s possible one of the Hardware failed. You can try to disassemble the laptop to bare minimum and try to reseat the hardware one by one and power on the laptop every time you reseat a hardware to know the failed one, replace the faulty hardware,
Some electronics components or chipset on the motherboard failed; Laptop HP G62-b31EE won’t turn on at all. Disassemble the laptop and take out the motherboard. With a Multimeter check electronics components continuity, Voltage and Chipset temperature, you will need an electronic Schematic Diagram for Laptop HP G62-b31EE. The failed electronic component has to be replaced, (How to test Laptop Power System). (Electronics components failure will be updated every time we fix this laptop)
BIOS failed; Laptop HP G62-b31EE won’t turn on at all, if the Power System and electronics components on the motherboard are good, there is chance you have failed BIOS, reprogram or replace the HP G62-b31EE BIOS chip (How to reprogram (Flash). Laptop BIOS).
Motherboard dead; The HP G62-b31EE motherboard has to be replaced.
For other HP G62-b31EE problems write a comment.