Lenovo Ideapad 510-15IKB disassembling procedure

To disassemble laptop Lenovo Ideapad 510-15IKB turns off the laptop and follows the steps below:

Warning: Electrostatic discharge (ESD) can permanently damage your laptop. Ware an ESD wrist strap when you work with the internal components. If it’s not available, get rid of the static by touching grounded metal objects (grounded appliance) once in a while.

1- Remove Hard disk drive

  • Remove the screws 1.
  • Remove the HDD cover in the direction shown by arrow 2.

2

Lift the hard disk drive slightly in the direction shown by arrow 3. Detach the HDD connector and then remove the hard disk drive from the slot in the direction shown by arrow 4.

3

2 – Remove Optical disc drive

Remove the screw 1. Pull the optical drive out in the direction shown by arrow 2.

4

3 – Remove Keyboard bezel

Disconnect the touchpad cable connector and the keyboard connector in the directions shown by arrows 1 and 2.

5

Remove the screws 3 and 4.

6

Separate the keyboard bezel and upper case in the directions shown by arrows 5 and 6.

7

Remove the keyboard bezel in the direction shown by arrow 7.

4 – Remove Battery pack

Remove the screws 1. Then remove the battery pack in the direction shown by arrow 2.

9

I am not responsible for what happens to your notebook as a result of you reading this!

One thought on “Lenovo Ideapad 510-15IKB disassembling procedure

  1. Sanjay

    Seriously its very risky brother to do so with your laptop. I would rather go to service centre instead of doing this.

Leave a Reply