Author Archives: helppard

Laptop Battery Socket Votage

Almost all modern laptops use Lithium Ion (LiIon) batteries. Each battery consists of at least a number of LiIon cells in a series ‘string’ and may consist of a number of parallel combinations of several series strings.

A Lithium Ion cell has a maximum charging voltage of 4.2 V (4.3 V for the brave and foolhardy). To charge a 4.2 V cell at least slightly more voltage is required to provide some “headroom” to allow charge control electronics to function.

At the very least about 0.1 V extra might do but usually at least 0.5 V would be useful and more might be used.

  • One cell = 4.2 V.
  • Two cells = 8.4 V.
  • Three cells = 12.6 V.
  • Four cells = 16.8 V.
  • Five cells = 21 V.

It is usual for a charger to use a switched mode power supply (SMPS) to convert the available voltage to required voltage. A SMPS can be a Boost converter (steps voltage up) or Buck converter (steps voltage down) or swap from one to the other as required. In many cases a buck converter can be made more efficient than a boost converter. In this case, using a buck converter it would be possible to charge up to 4 cells in series.

there is laptop batteries with:

  • 3 cells in series (3S),
  • 4 cells in series (4S),
  • 6 cells in 2 parallel strings of 3 (2P3S),
  • 8 cells in 2 parallel strings of 4 (2P4S)

and with a source voltage of 19 V it would be possible to charge 1, 2, 3 or 4 LiIon cells in series and any number of parallel strings of these.

For cells at 16.8 V leave a headroom of (19−16.8) = 2.4 volt for the electronics. Most of this is not needed and the difference is accommodated by the buck converter, which acts as an “electronic gearbox”, taking in energy at one voltage and outputting it at a lower voltage and appropriately higher current.

With say 0.7 V of headroom it would notionally be possible to use say 16.8 V + 0.5 V = 17.5 V from the power supply—but using 19 V ensures that there is enough for any eventuality and the excess is not wasted as the buck converter converts the voltage down as required. Voltage drop other than in the battery can occur in SMPS switch (usually a MOSFET), SMPS diodes (or synchronous rectifier), wiring, connectors, resistive current sense elements and protection circuitry. As little drop as possible is desirable to minimise energy wastage.

When a Lithium Ion cell is close to fully discharged it’s terminal voltage is about 3 V. How low they are allowed to discharge to is subject to technical considerations related to longevity and capacity. At 3 V/cell 1/2/3/4 cells have a terminal voltage of 3/6/9/12 volt. The buck converter accommodates this reduced voltage to maintain charging efficiency. A good buck converter design can exceed 95 % efficient and in this sort of application should never be under 90 % efficient (although some may be).